Water Heater Installation and Repair

A water heater that stops working means cold showers and disrupted daily routines. Homeowners usually call when they notice leaking, strange noises, or no hot water at all. The situation can be urgent, especially with a full tank of water sitting on the floor. We understand the stress and respond quickly to assess the problem.

We start by checking the thermostat, heating elements, and pressure relief valve. For gas units, we inspect the thermocouple and burner assembly. Tools include a multimeter, pipe wrench, and tubing cutter. If a repair is possible, we replace faulty parts. For a full replacement, we disconnect the old unit, drain it, and remove it. Then we adjust the plumbing and venting as needed.

The job varies based on the unit type, tank versus tankless, and the fuel source. Access matters: a unit in a cramped closet or attic takes more time. The condition of existing connections, such as corroded pipes or outdated venting, can add work. Local climate affects freeze protection requirements. These factors influence the overall time and cost, not a fixed price.

On installation day, we protect the work area with drop cloths and move furniture if needed. We disconnect and remove the old heater, then install the new unit, testing for leaks and consistent temperature. Afterward, we clean up all debris and old parts. Homeowners should clear the area around the unit and ensure pets are secured. No special preparation is needed beyond that.